Off-set Angle Adapter/Angle Screw Adapter/Torque Setting Adapter (see figures B–E)
You can drive in screws close to edges using the off-set angle adapter (13).
The angle screw adapter (14) allows you to drive in screws in hard-to-reach areas.
The torque presetting ring (16) on the torque setting adapter (15) can be used to pre-select the required torque in 10 stages. When the correct setting is used, the application tool will be stopped when the screw is driven flush into the material or once the set torque has been reached.
Assembly (see figures B–C)
To fit the adapters, pull off the worklight cover (7) towards you. Then the adapters can be attached. It is possible to fit an adapter offset by 45°.
Removal (see figures D–E)
To remove an adapter, turn the unlocking ring (23) in rotational direction ➊ and pull the adapter off towards you. Then reattach the worklight cover (7).