Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- Make sure that the base unit cannot draw in dust or other contamination during operation.
- Make sure never to spray on the base unit.
- Stop spraying if fluid escapes from places other than the intended nozzle during spraying, and restore the spray gun to its proper condition. There is a risk of electric shock.
- Do not direct the fine-spray system against yourself, other persons or animals.
Switching on (see figure E)
- Check whether the correct paint nozzle is fitted.
- Plug the mains plug into a plug socket.
- Grasp the spray gun by the handle and point it at the target area.
- Slide the on/off switch (22) forwards.
- Pull the trigger switch (6) on the spray gun.
Note: Air always flows out at the air cap (2) when the base unit is switched on.
Switching Off
- Let go of the trigger switch (6) and slide the on/off switch (22) backwards.
- Pull the mains plug from the plug socket.