Starting Operation

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Make sure that the base unit cannot draw in dust or other contamination during operation.

Make sure never to spray on the base unit.

Stop spraying if fluid escapes from places other than the intended nozzle during spraying, and restore the spray gun to its proper condition. There is a risk of electric shock.

Do not direct the fine-spray system against yourself, other persons or animals.

Switching on (see figure E)

Check whether the correct paint nozzle is fitted.
Plug the mains plug into a plug socket.
Grasp the spray gun by the handle and point it at the target area.
Slide the on/off switch (22) forwards.
Pull the trigger switch (6) on the spray gun.

Note: Air always flows out at the air cap (2) when the base unit is switched on.

Switching Off

Let go of the trigger switch (6) and slide the on/off switch (22) backwards.
Pull the mains plug from the plug socket.