Measuring functions

You will find the following functions in the Functions menu:

  • Length measurement
  • Area measurement
  • Volume measurement
  • Continuous measurement
  1. Press the  button as many times as needed for the indicator for the required function to appear in the display (5).
  2. To confirm the selection, press the  button.

  1. Press the  button as many times as needed for the indicator for length measurement  to appear in the display (5).
  2. Press the  button to confirm the selection.
  3. Briefly press the  button to switch on the laser.
  4. Aim the laser point at the target.
  5. Press the  button again to start the measurement.
  6. The measured value is displayed in the result line (d).
  7. Repeat the above-mentioned steps for each subsequent measurement.

By pressing the measuring button  for a long time, you get to the length measurement function  from all measuring functions.

If several length measurements are taken in a row, the results of the last measurements are displayed in the measured value lines (c). The last measured value is at the bottom of the display, the penultimate measured value is above it, and so on.

  1. Press the   button as many times as needed for the indicator for area measurement  to appear in the display (5).
  2. Press the  button to confirm the selection.
  3. Briefly press the  button to switch on the laser.
  4. Aim the laser point at the target.
  5. Press the  button again to start the measurement, e.g. the length of a room.
  6. Press the  button to start the second measurement, e.g. the width of a room.

After the second measurement has been completed, the area will be automatically calculated and displayed. The result is displayed in the result line (d). The individual measured values are in the measured value lines (c).

  1. Press the   button as many times as needed for the indicator for volume measurement  to appear in the display (5).
  2. To confirm the selection, press the  button.
  3. Briefly press the  button to switch on the laser.
  4. Aim the laser point at the target.
  5. Press the  button again to start the measurement, e.g. the length of a room.
  6. Press the  button to start the second measurement, e.g. the width of a room.
  7. Press the  button to start the third measurement, e.g. the height of a room.

After the third measurement has been completed, the volume will be automatically calculated and displayed. The result is displayed in the result line (d). The individual measured values are in the measured value lines (c).

During continuous measurement, the measured value is continually updated. You can, for example, move a required distance away from a wall while reading off the current distance at all times.

  1. Press the  button as many times as needed for the indicator for continuous measurement  to appear in the display (5).
  2. To confirm the selection, press the  button.
  3. Briefly press the  button to switch on the laser.
  4. Aim the laser point at the target.
  5. Move the measuring tool until the required distance is displayed in the result line (d).
  6. You can interrupt the continuous measurement by briefly pressing the  button.
  7. Press the  button again to continue the continuous measurement.

The current measured value is displayed in the result line (d), and the maximum and the minimum measured value in the measured value lines (c).

Continuous measurement switches off automatically after 4 min.