Inserting screwdriver bits (see figure D)

Only apply the power tool to the screw/nut when the tool is switched off. Rotating tool inserts can slip off.

A universal holder (19) with SDS-plus shank (accessory) is required to work with screwdriver bits.

Clean and lightly grease the insertion end of the shank.
Insert the universal holder into the tool holder while turning it until it locks automatically.
Check that it is locked by pulling the universal holder.
Insert a screwdriver bit in the universal holder. Only use screwdriver bits that fit the screw head.
To remove the universal holder, slide the locking sleeve (4) backwards and remove the universal holder (19) from the tool holder.