Operating Modes

The measuring tool has several operating modes, which you can switch between at any time:

• Cross-line mode (see figures A–B): Generates one horizontal and one vertical laser line,
• Cross-line and plumb point mode (see figure C): Generates one horizontal and one vertical laser line as well as top and bottom plumb points,
• Plumb point mode: Generates two plumb points – one facing up, the other down.

Once the measuring tool has been switched on, it is in cross-line operation with automatic levelling.

To change the operating mode, press the button for laser operating mode (4) as often as required until the laser beams are generated in the required operating mode.

All operating modes can be used with both automatic levelling and the incline function.