Starting Operation
- Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.
- Make sure that the base unit cannot draw in dust or other contamination during operation.
- Make sure never to spray on the base unit.
- Stop spraying if fluid escapes from places other than the intended nozzle during spraying, and restore the spray gun to its proper condition. There is a risk of electric shock.
- Do not direct the fine-spray system against yourself, other persons or animals.
Switching on (see figure D)
- Check whether the correct nozzle cap is fitted. see Changing the nozzle cap (see figures B1–B2)
- Plug the mains plug into a plug socket.
- Grasp the spray gun by the handle and point it at the target area.
- Switch on by pressing the on/off button (25).
- Set the on/off button (25) to the required application to regulate the air flow see Setting the air flow (see figure D).
- Pull the trigger switch (5) on the spray gun.
Note: Air always flows out at the air cap (2) when the base unit is switched on.
Switching off
- Let go of the trigger switch (5) and switch off by pressing the on/off button (25).
- Pull the mains plug from the plug socket.